Download Hardware Owner`s Manual

Transcript
Table 1-2.
System Messages (continued)
Message
Causes
Corrective Actions
Alert! iDRAC6 not The iDRAC6 is not
Wait for the system to
responding.
responding to BIOS
reboot.
Rebooting.
communication either
because it is not functioning
properly or has not
completed initialization.
The system will reboot.
Alert! iDRAC6 not
responding.
Power required
may exceed PSU
wattage.
The iDRAC6 is hung.
Alert! Node
Interleaving
disabled! Memory
configuration
does not support
Node
Interleaving.
The memory configuration
does not support node
interleaving, or the
configuration has changed
(for example, a memory
module has failed) so that
node interleaving cannot be
supported. The system will
run but without node
interleaving.
The iDRAC6 was remotely
reset while system was
booting
Remove AC power to the
system for 10 seconds and
restart the system.
After AC recovery, the
Alert!
iDRAC6 takes longer than
Continuing
normal to boot.
system boot
accepts the risk
that system may
power down
without warning.
38
About Your System
Ensure that the memory
modules are installed in a
configuration that supports
node interleaving. Check
other system messages for
additional information for
possible causes. For memory
configuration information,
see "General Memory
Module Installation
Guidelines." If the problem
persists, see
"Troubleshooting System
Memory."