Download 6150 Power Sweeper

Transcript
OPERATING INSTRUCTIONS
BEFORE STARTING
1. Set Parking Brake.
2. Make sure all controls are in the “Off” position.
3. Be sure accelerator and directional control pedal is in neutral.
PRE-START CHECK LIST
Before starting the engine, perform these pre-start checks.
1. Check engine air filter element indicator.
2. Check engine oil level.
3. Check radiator coolant level.
4. Check hydraulic fluid level.
5. Check fuel level.
6. Check all systems for leaks.
7. Check brakes and controls for proper operation.
8. Check broom patterns
9. Check to ensure that all covers, panels and access doors are securely closed.
NOTE
When Machine Has Been Stored In Below Freezing Temperatures, Run Engine At A Low Idle Speed
With Machine Standing Still For 5 To 10 Minutes To Warm Engine And Hydraulic Oil.
TO START BATTERY MACHINES
Starting the battery powered models is accomplished by turning the key switch to the “I” (on) position. It is
important to note that the batteries should be fully charged and serviced prior to using the machine.
TO CHARGE BATTERIES
Charge the batteries at the end of each day or when the battery condition meter indicates low battery
voltage. The batteries need to be charged when the needle stays in the “red” zone while the machine is being
operated. When charging batteries, only use the quick disconnect provided ensure correct polarity. Follow
the “Battery Charging Instructions” provided in the service section of this manual.
TO START GAS ENGINE
Use the choke in extremely cold temperatures, (under 32 F. or 0 C.),
1. Pull choke if needed.
2. Adjust the throttle to a low engine speed setting.
3. Turn key to “START” position until engine starts, then release. (The key switch will return to the “ON”
position.)
4. Push in choke after engine starts running (If used).
TO START PROPANE ENGINE
Perform these checks in addition to the Pre-Start check list.
1. Check connections for leaks
2. Open the LP storage tank valve.
3. Check the regulator. Momentarily press fuel primer on the regulator cover to bleed air out of the system.
4. Adjust the throttle to a low engine speed setting.
5. Turn key to “START” position until engine starts, then release. (The key switch will return to the “ON”
position.)
24 - FORM NO. 56041704
American-Lincoln
6150