Download 3120933 Rev -
Transcript
SECTION 5 – SWING DRIVE GENERAL The rotation capability of the crane is also referred to as the swing. A hydraulically-driven gear motor drives a speed reducer gearbox which outputs into a large, internal-tooth ball bearing. The static brake, mounted between the motor and gear reducer, prevents rotation until the swing motor is pressurized. The swing motor is driven by the end section of the pump with a maximum of 8 gpm. The swing drive may be removed as a unit from the turntable or components may be removed as necessary starting with the motor, brake, and gear reducer. An optional swivel assembly provides full 360° rotation of the turntable by allowing hoses and wires to rotate. The top portion of the swivel is a slip ring. The lower portion is a hydraulic swivel. Recommended rotation speed is one revolution per minute. To attain that speed, the PTO ratio is selected to provide pump output at or near maximum engine speed. If an incorrect PTO is installed, one rpm rotation speed will not be attainable. Refer to the Operating and Safety Manual for information on PTO selection. COUNTERBALANCE VALVE A dual counterbalance valve mounted on the inside of the turntable balances the pressure between left and right swing. Without the counterbalance valve the swing motor would drive the pump backwards until the boom stopped rotating. When one side is pressurized the “off” side recieves a small amount of pressure to prevent cavitation. The counterbalance cartridge maintains the offside pressure at one-third of the pressure side. If rotation of the crane is jerky or one direction of rotation is faster than the other, the counterbalance valve may be suspect. WARNING: NEVER OPERATE BOOM WITHOUT OUTRIGGERS SET ON A FIRM SURFACE. 1. Park the machine in an open area and set the outriggers. 2. Place a 4000 psi pressure gauge in each of the hoses going into the counterbalance valve. 3. Using all applicable safety practices, operate the boom and monitor the pressures on each gauge. The higher pressure should be three times that of the lower pressure. 4. If gauge readings are not properly set, replace the counterbalance valve. Figure 5-1. Swing Drive Components 3120933 Rev. 0 USTC 5-1