Download original - Linfo

Transcript
Revised Dec 97
SPEAKER UNITS
FAULTY UNITS.
TREBLE UNITS (continued)
Finally this can be confirmed by opening the unit and checking for
damage. If the coils have no sign of over-driving then measure with the
meter. It is possible to scrape off some of the enamel of the coil wire in
the middle of the coil and measure to each of the solder terminals, this
will tell you which side the fault is on. Then by examining the joint with
a magnifying glass (or microscope) you may be able to see the poor
joint. This can occur because the enamel was not removed properly
before the joint was soldered.
MID-RANGE AND BASS UNITS.
VOICE COIL OFF-CENTRE.
The speaker has been wrongly assembled and the voice coil is off
centre, so that it rubs the magnet and causes distortion. The easiest
way to check for this is to use a signal generator and sweep through the
frequencies slowly until you hear the distortion.
It is sometimes possible to feel this by hand, by gently pushing the cone
in with your hand, but you must do this evenly in a straight piston motion
in line with the cone movement or you will distort the cone and make it
rub.
SURROUND UN-GLUED
It is possible to try carefully to glue this using CYANO-ACRYLIC,
(known as "superglue") or contact adhesive but these repairs are not
always successful as the repair must be air tight.
If you are in any doubt about a faulty speaker unit and do not wish to
open the unit yourself, they can be returned to Linn Service for checking.
Follow the normal returns procedure as descibed in the returns procedure. It is important to ensure that speakers are properly packed for
return, using original boxes. Contact Linn Sevrice before returning and
remember that we may need the pair back.
Index
Copyright © 1991-1997 by Linn Products Limited. All Rights Reserved.
Page 7