Download TWIN DISC

Transcript
Removal from Vessel
Twin Disc, Incorporated
3.
Remove the cotter pin and jam nut. Loosen the propeller nut until it is
flush with the end of the shaft to prevent damage when the propeller
moves from the tapered pilot. Remove the propeller from the splined
shaft using suitable pullers, soft blocks and mallets as necessary,
allowing the propeller to stop against the spacer and propeller nut.
Remove the propeller nut, spacer, and propeller from the rear end of
the propeller shaft.
Figure 35. Propeller Retaining Parts (left), and Propeller Installed
(right)
4.
Drain the oil from the Arneson Surface Drive through the drain holes
in the housings or from the lower oil reserve hose inside the boat.
Arneson Surface Drive Service Manual #1020915
93