Download 2006 ST1300/A SET
Transcript
17. Service and install the battery (cont.). Remove the battery cover. Remove the battery holder by removing the bolt. NUTS AND BOLTS CAP Pull the battery out of the battery box. Remove the cap and the packed battery nuts and bolts. The battery in this motorcycle is a precharged, maintenance-free type. The electrolyte has been added at the factory. BATTERY Follow the instructions included in Service Letter #48. Make sure the ignition switch is in the OFF position. BATTERY HOLDER BATTERY COVER BOLT Lower the battery into the battery box. Connect the positive (+) battery cable to the positive (+) battery terminal. Then connect the negative (-) battery cable to the negative (-) battery terminal using the special bolts and nuts. BOLTS POSITIVE (+) CABLE NEGATIVE (-) CABLE Tighten the bolts securely. Coat both terminals with clean dielectric grease and pull the red cover over the positive terminal. Allowing the positive (+) cable to rest on any metal parts could wear through the insulation and cause a short circuit. Do not allow the positive (+) cable to contact any metal parts. NUTS Verify the correct battery cable routing by referring to step 16. Reinstall the battery holder, bolts, battery cover, and side cover in the reverse order of removal. ©2006 American Honda Motor Co., Inc. - All Rights Reserved 17