Download specifications platform ladder

Transcript
A Specialty #2150 hand held spotlight with mounting bracket shall be provided. It shall be
located officer`s side with a 12 volt receptacle.
Backing Lights
A pair of Zico #ZQL-SS-H7614 sealed beam backing lights shall be provided. The lights shall
have a polished stainless steel housing. Each light shall provide additional lighting for backing
the vehicle and shall operate when the vehicle is placed in reverse and tied in to the corning light
circuit
The lights shall be located center of rear wheel well.
Foot Switch
A heavy duty metal floor mounted foot switch shall be installed to operate the air horns. It shall
be located officer's side.
Foot Switch
A heavy duty metal floor mounted foot switch shall be installed to operate the Q2B siren. It shall
be located driver's side, officer's side.
Rocker Switch
A 12 volt rocker switch shall be installed.
The switch shall be located driver rear of body for rear work lights.
Switch
A relay shall be provided to allow operation of the specified 120/240 volt device from a remote
location other than the circuit breaker box. The relay shall be mounted in a weather resistant
enclosure mounted near the breaker box. A remote switch shall be mounted as specified.
Location: programmed to multiplex display for driver's side cab/body 120/240V scene light(s),
programmed to multiplex display for officer's side cab/body 120/240V scene light(s), driver side
of cab dash electrical access panel for quartz lights at tip of aerial (aerial circuit), programmed to
multiplex display for 120/240V scene light(s) at tip of aerial (aerial circuit).
Cab Tilt Switch
The cab tilt shall be controlled by Ramsey weatherproof momentary action push-button switches
connected to a cord. The cord shall control tilting and lowering functions of the cab and have an
extended length of 36”.
The plug-in for the control shall be located next to manual cab tilt pump.
Rear Cab Heater Switch
A 12V rocker switch or toggle (if applicable) shall be provided for the rear cab heater(s).
The switch location and function: interior cab rear facing officer side 3X3 for driver and officer
side cab heaters.
Two-Way Intercom
A two-way Atkinson Dynamics (Federal Signal) intercom system shall be installed to provide
communications between the turntable control station and the aerial tip. The system shall consist
of a 12 volt transistorized amplifier and two (2) waterproof speaker / microphones.
In addition to the combination speaker / microphone, the turntable shall include a volume control
and a push to talk button. The speaker / microphone at the tip shall be hands free operation.
Camera Back-Up
There shall be a Safety Vision camera model number SV-625B-KIT provided. The camera shall
be mounted up high at the rear of the vehicle to provide a wide angle rear view with audio. The
camera shall include a cable with metallic waterproof threaded o-ring seal connectors to ensure
positive connection between video cable and camera to prevent unplugging due to vibration