Download MAINTENANCE INTERVALS - Safety

Transcript
137
Maintenance Section
Elevator Chain - Inspect/Adjust
i00963198
Adjust the Elevator Chain
Elevator Chain - Inspect/Adjust
SMCS Code: 6231-025; 6231-040
S/N: 5SG480-Up
Inspect the Elevator Chain
Illustration 151
g00490922
1. Remove the jack (5) which is located under the
scraper. The jack is located near the push block.
Illustration 150
g00490921
Inspect the slack of the elevator chain. Inspect
the slack at the widest space that is between the
arrows. The upper arrow is located at the lower
edge of the frame assembly for the elevator. The
lower arrow is on the upper side of the elevator
chain. The widest space will be halfway between
the upper sprocket and the lower idler. The slack
in the elevator chain should be 254 to 356 mm
(10 to 14 inches). Adjust the elevator chain when
the distance between the arrows exceeds 356 mm
(14 inches).
Illustration 152
g00490923
Typical Example
The elevator chain should be inspected for wear.
Measure the length of 10 chain links. Replace the
elevator chain if the 10 links measure more than
1079 mm (42.5 inches). Refer to Disassembly and
Assembly, SENR6809, “Elevator Flight Assemblies
and Chain Assemblies” for further information.
2. Remove the pins (6) from the jack.
Note: Failure to replace a worn elevator chain will
result in excessive wear to the drive sprockets.
4. Extend the jack until the pressure is off of the
adjusting bolt (3). Remove the adjusting bolt.
3. Attach one end of the jack to the frame assembly
for the elevator (1). Adjust the jack until the other
end of the jack can be attached to the adjuster
arm (2).
5. Extend the jack until the desired tension of the
chain is achieved. Install the adjusting bolt (3).
The adjusting bolt must be secured in the rail (4).
6. Shorten the jack in order to relieve the pressure
on the mounting pins for the jack. Remove the
mounting pins in order to remove the jack.
7. Repeat Steps 3 through 6 in order to adjust the
other elevator chain.
8. Install the mounting pins in the jack. Install the
jack in the storage area that is under the scraper.