Download bizhub 282

Transcript
bizhub 282
Controller - no or slow print, scan failure, garbled data, lockup
CAUSE: Failed Fax Kit (FK-503).
SOLUTION: Replace the FK-503 board (p/n 4551 2048 01).
SPECIAL NOTE : Solution contribution by Mark D'Attilio, Production Print/SSD
Solution ID
TAUS0651130EN*
Solution Usage
2
Description
FK-503, will not transmit (TX)or receive (RX).
Solution
PROBABLE CAUSES:
1.A 4-conductor cable was used to conntect to the phone jack.
Connect the machine to the phone jack using a 2-conductor line.
After installing the ML-502, when faxing from the second line, no TX or RX functionality
2. Dual line fax not enabled.
To enable the dual line fax, perform the following:
a.In the Copy mode enter the Tech Rep mode by pressing Utility button, Check detail tab, Meter count, Stop, 0, 0, Stop 0, 1.
b.Press the Softswitch mode.
c. Enter 006 in the mode selection area.
d. Change bit switch 1 to 0.
Whentransmitting to a remote fax, the remote fax will answer the call, but during the "Handshake Mode" the FK-503 will drop the line and go into "Redial
Mode".
If the FK-503 is receiving a fax, it will pick up the call, but during the "Handshake Mode" it will drop the line.
3. Attenuation level set too low.
Reset softswitch "Mode 086" bits 7 and 6 to 00. This will increase the attenuation level to 0 dB (-48 dBm) from 5 db (-43dbm).
SPECIAL NOTE : Solution contribution by Bill Hall, Workgroup/SSD; KM Great Britain (BGB) and Mark D'Attilio, Production Print/SSD
Solution ID
TAUS0900943EN*
Solution Usage
1
Description
No Address Found when performing LDAP search to Netware server
Solution
CAUSE:The attribute "statusMember"on the Novel LDAP server was missing or bad.
SOLUTION:Using iManager, under LDAP,find the attribute"statusMember"and map the attributeStatusMember to member:x-status. Click OK.The names
should start to be pulled in the LDAP search.
SPECIAL NOTE: Solution contribution by Paul Santangelo, ESS/BSE
Solution ID
TAUS0902709EN*
Solution Usage
1
Description
Scanning to a Gmail© account fails. Errors EA0004, E73000, EA2212or EAA002 may be indicated.
Solution
CAUSE:With Gmail©, the MFP must support SMTP over SSL/TLS.The bizhub 200/250/350 and bizhub 222/282/362 series do not support this functionality.
SOLUTION:An E-mail server that does not require support for SMTP over SSL/TLSwould have to be used.
SPECIAL NOTE : Solution contribution by Ron Reed, SSD Training and Bill Hall, Workgroup/SSD
Solution ID
TAUS0807940EN*
Solution Usage
0
Description
PROBLEM: The machine does not recognize the USB port. When the machine is connected to a local pc, the pc never recognizes the machine is connected.
Solution
CAUSE: The machine is set for DHCP. When the machine is set for DHCP, it will bypass the USB port as it has to connect to a DHCP server on the network
for an ip address.
Copyright 2010, Konica Minolta Business Solutions U.S.A., Inc.
March 2010
5