Download TWIN DISC

Transcript
Assembly
Twin Disc, Incorporated
Bearing Preload Measurement and Shimming
Note: Place the transmission on the front housing. Be sure the
transmission is securely supported.
General
There are two means of measuring the shaft end play to determine the
appropriate amount of shims necessary to obtain the required shaft bearing
preload. One method is to measure the shaft movement while using a dial
indicator and the other method is to use a depth micrometer to calculate the
clearance available for shims. Both methods require the use of a Special Ground
Bearing Cup. Due to limited access through the manifold opening, the depth
micrometer measurement may be the desireable method on this transmission.
1.
Install two Special Tools, TD-21552-101or equivalent tool, at the primary
shaft with the two 1/4 - 20 threaded rods or screws to load the bearing
cup.
a.
Locate the two tool halves such that a load can be applied to the
bearing cup in two locations 180° apart.
b.
Clamp the tools to the housing using the appropriate capscrews
with washers. Torque the capscrews to the standard torque valve
as shown in Description and Specifications.
MG_311
Figure 118. Special Tools TD-21552-101
Marine Transmission Service Manual 1022127
141