Download ISSION O`MATIC

Transcript
COMPONENT
SERVICE-MAINSHAFT
I
REASSEMBLY
l-2 and 3-4 synchronizer
1. Mate synchronizer
hub with sleeve using mark made at
disassembly. Make sure that hub and sleeve slide smoothly. If they slide unsmoothly,
replace hub and sleeve
assembly.
2. 34 synchronizer sleeve has teeth missing at six portions.
Assemble hub to sleeve in such a way that center tooth
“T” between two missing teeth will touch synchronizer
key. (110012)
T
Synchronizer
3.
Use care when installing 3-4 synchronizer hub since only
3-4 synchronizer
is directional.
Smaller diameter
side
“A” of center boss is front of 3-4 synchronizer hub.
Teeth
missing
here
key
-
’
I
4. Insert three keys into groove of
5. Install two synchronizer springs
When synchronizer
springs are
front and rear ones are not
(110013)
synchronizer hub.
to synchronizer.
installed, make sure that
faced in same direction.
145025
1
21-59