Download BRADEN - Winches, Inc.
Transcript
21. Install the tie plates next. Position the plates so that the curved part is toward the top of the hoist and curving away from the drum. Install the sixteen (16) capscrews and lockwashers (twenty for CH185A and C2H185A). 18. Install the motor end plate and then the brake cylinder nipple, using a good grade of thread sealant. 19. Lubricate the o-ring and install it on the outside of the brake cylinder. Push it down until it’s resting against the motor end plate. 22. Install the tee and hydraulic hoses at this time. Use a good grade of thread sealant, being careful not to get it in the hydraulic lines, as it could block an orifice in the brake valve. The long hose should point to the right as viewed from the motor end. 20. Install the motor adapter with eight (8) special BRADEN capscrews and lockwashers. 23. Lubricate and install a new O-ring around the pilot on the motor. 32