Download System Control Manual

Transcript
SYSTEM CONTROL INSTALLATION, OPERATION AND SERVICE MANUAL
SECTION 4: TYPICAL EXTERNAL WIRING
DIAGRAMS
DANGER
burners can be either CORAYVAC®, CORAYVAC® SF
or VANTAGE® NP (multiburner only).
The zones are connected to a single pump, unless
zone 3 and/or zone 4 are selected to function with
the optional pump 2. The external wiring diagram
below shows connection to an EP-100 or EP-201 120
V 1 Ø pump.
4.1.1 External Wiring Connection Details
Electrical Shock Hazard
Disconnect electric before service.
More than one disconnect switch may be
required to disconnect electric to the unit.
Failure to follow these instructions can result
in death or electrical shock.
4.1 EP-100 or EP-201 120 V 1 Ø Pump External
Wiring Diagram
Low voltage wiring (pressure switch, thermostats)
must be rated to 300 V. Line voltage wiring must be
rated to 600 V.
The low voltage circuit conforms with Class 2 separation of circuit requirements. National Electrical
Codes® for wiring class 2 low voltage circuits must be
followed.
As per individual building specifications for class of
cable to be used. Use copper conductors only.
The external wiring diagram below shows the connections for four zones of system burners. System
FIGURE 6: External Wiring Diagram ROBERTS GORDON® EP-100 and EP-201 120 V 1 Ø Pump
Note: For applications requiring zones to share thermostats, see Page 14, Section 4.6
8 of 19