Download Chapter 4 Chrysler Testing - Snap-on

Transcript
Chapter 4
Testing ABS Systems
the ABS data stream. The ABS CODES & DATA selection requires communication with the
ABS ECM through the same diagnostic connector used for CCD testing.
z
To ensure efficient communication with the ABS ECM when using Codes & Data:
1. Be sure the ignition is switched off when entering the vehicle ID.
2. Switch the ignition on before selecting CODES & DATA.
3. Switch the ignition off after completing the tests.
Bendix Systems
A Codes & Data display is available for models with Bendix 4, ABX-4, Bendix 6 and Bendix 10.
A typical Bendix ABS Codes & Data screen is shown in Figure 4-56.
PUMP_______OFF
** CODES & DATA.
NO CODES PRESENT
SYSTEM RELAY_____ON
MP MONITOR(V)__13.2
OK TO DRIVE **
SYSTEM RLY(V)__13.2
Figure 4-56 Sample Bendix 4 Codes & Data display
In the ABS Codes & Data mode, the antilock functions of the Bendix systems are fully
functional, and new trouble codes may set. The vehicle may also be driven for testing.
Teves Systems
There are currently three Teves ABS systems used by Chrysler:
• Mark IV
• Mark IVg
• Mark 20
The ABS data parameters vary depending on which system is installed on the vehicle,
however, the display is similar for all three (Figure 4-57).
BRAKE SW___CLSD
** CODES & DATA.
NO CODES PRESENT
FLS SW #2_______OPEN
MOTOR SPEED_____OFF
OK TO DRIVE **
PED TRVL SNS_____??
Figure 4-57 Sample Teves ABS Codes & Data display
When in the ABS Codes & Data mode, the antilock functions of Teves systems are not fully
functional. The vehicle can be driven safely for testing, new codes do not set.
Kelsey-Hayes, TRW
Dodge trucks, SUVs, and full-sized vans currently use two different types of ABS:
• EBS-125 RWAL
46