Download Transmission
Transcript
TRANSMISSION Symptom: *CHECKING PARK/NEUTRAL SWITCH OPERATION POSSIBLE CAUSES INTERMITTENT WIRING AND CONNECTORS PARK/NEUTRAL SWITCH SENSE CIRCUIT OPEN PARK/NEUTRAL SWITCH SENSE CIRCUIT SHORT TO GROUND PARK/NEUTRAL POSITION SWITCH POWERTRAIN CONTROL MODULE - PARK NEUTRAL SWITCH TEST 1 2 ACTION Ignition on, engine not running. With the DRBIIIt, monitor the PNP Switch Input status. Move the gear selector through all gear positions, Park to 1st and back to Park. Did the DRB display P/N and D/R in the correct gear positions? Yes → Go To 2 No → Go To 3 The condition is not present at this time. Using the schematics as a guide, inspect the wiring and connectors specific to this circuit. Wiggle the wires while checking for shorts and open circuits. Were there any problems found? Yes No 3 4 APPLICABILITY → Repair as necessary. Perform 45RFE/545RFE TEST - VER 1. TRANSMISSION 5-SPD AUTOMATIC 5-45RFE TRANS 5-SPD AUTOMATIC 5-45RFE TRANS VERIFICATION → Test Complete. Turn the ignition off to the lock position. Disconnect the PCM harness connector. Disconnect the PNP Switch harness connector. Check connectors - Clean/repair as necessary Measure the resistance of the PNP Switch Sense circuit between the PCM harness connector and the PNP Switch harness connector. Is the resistance below 5.0 ohms? Yes → Go To No → Repair the PNP switch sense circuit for an open. Perform 45RFE/545RFE TRANSMISSION VERIFICATION TEST - VER 1. 5-SPD AUTOMATIC 5-45RFE TRANS 4 Ignition on, engine not running. Disconnect the PCM harness connector. Disconnect the PNP Switch harness connector. Check connectors - Clean/repair as necessary Measure the resistance between the PNP Switch Sense Circuit and ground. Is the resistance below 5.0 ohms? Yes → Repair the PNP switch sense circuit for a short to ground. Perform 45RFE/545RFE TRANSMISSION VERIFICATION TEST - VER 1. No → Go To 5 213 5-SPD AUTOMATIC 5-45RFE TRANS