Download Service manual

Transcript
Service manual
Torque
All screw connections must be tightened with the torques specified in the following
instructions.
Checks
Visual check
Check the entire frame for cracks, especially the areas around joints and welded seams.
Checking the screw connections
Check all screw connections with the torques specified in the instructions.
M must be secured again using new safety seals.
Several screw connections have been secured with safety seals. If these are opened, they
Identifying and alleviating malfunctions
Malfunction
The wheelchair will not
move in a straight line
Possible cause
Measure
Incorrect tire pressure in a rear wheel
Correct tire pressure
One or more spokes broken
Replace defective spoke(s)
Spoke unevenly tensioned
Dirty or damaged wheel bearings
Rear wheels have been fitted too far forward
The wheelchair tips
Backrest angle too great
backwards too easily
Seat angle too great
The brakes engage poorly or Incorrect tire pressure in one or both rear wheels
asymmetrically
Brake setting incorrect
Tighten excessively loose spokes
Clean or replace bearings
Fit rear wheels further back
Reduce backrest angle
Use longer vertical struts
Correct tire pressure
Correct brake setting
Insufficient tire pressure in the rear wheels
Correct tire pressure
Rear wheels are not parallel
Ensure that the rear wheels are parallel
Insufficient tension in the front wheel bearings block
Lightly tighten the nut in the bearings block
axle
Front wheel is worn flat
Replace front wheel
The front wheel is stiff or
stuck
Dirty or damaged bearings
Clean or replace the bearings
Increased forward tip
tendency
Frame deformed
Replace frame
Roll resistance is too great
The front wheels wobble
when moving fast
5
© Küschall AG, Schweiz | 2010-11