Download CHAPTER 1 INTRODUCTION
Transcript
2-3 Connecting the Load Cell ※Do not plug in your power cable until you have completely connected the load cell. Screw Signal 1 Positive Excitation Voltage, (EXC+) 2 Positive Sense Voltage, (SEN+) 3 Negative Sense Voltage, (SEN-) 4 Negative Excitation Voltage, (EXC-) 5 Positive Signal Voltage, (SIG+) 6 Negative Signal Voltage, (SIG-) 7 Shield, (SHD) LTo connect your load cell to the weighing Indicator use a six-wire cable with shield-connect the wires as indicated above. If the JIF-2002 is located near the Load Cells (Within five meters or a few yards) you may use a 4-wire cable with shield, but first connect screws 1&2 and 3&4 with independent jumper leads. LThe analogue output from the Load Cell and input/output signals are sensitive to electrical noise. Do not bind these cables together as it could result in cross-talk interface. Please also keep them away from AC power cables. ※ It could be dangerous by using improper battery or wrong connection of battery. JIF-2002 WEIGHING INDICATOR&CONTROLLER 7