Download Ithaca 9000 Programmer`s Guide

Transcript
[ESC] C
Set form length in lines
ASCII
Hexadecimal
Decimal
IPCL
EPOS
[ESC] C <n>
1BH 43H <n>
<27> <67> <n>
&%SL <m1> <m2>
[ESC] C <n>
Description
The [ESC] C <n> command sets the form length to <n> lines at the
current line spacing. If the current page position is greater than the new
page length, the command also sets the current position as the top of
form.
[ESC] C [NUL]
Set form length in inches
ASCII
Hexadecimal
Decimal
IPCL
EPOS
[ESC] C [NUL] <n>
1BH 43H <0> <n>
<27> <67> <0> <n>
&%SI <m1> <m2>
none
Description
The [ESC] C [NUL] <n> command sets the form length to <n> inches. If
the current page position is greater than the new page length, the
command also sets the current position as the top of form. If zero inches
are specified, the form feed and vertical tab commands are ignored.
[ESC] 5
Begin auto line feed
ASCII
Hexadecimal
Decimal
IPCL
IPCL
EPOS
[ESC] 5 <n>
1BH 35H <n>
<27> <53> <n>
&%MA (Begin)
&%CA (End)
none
Description
The [ESC] 5 <1> command sets auto line feed mode. [ESC] 5 <0>
command ends auto line feed mode.
Note: The begin or end auto line feed command overrides the
configuration setting.
76