Download STM8 bootloader - STMicroelectronics

Transcript
Bootloader command set
3.3
Erase memory command
The erase memory command allows the host to erase sectors of the Flash program
memory/data EEPROM.
The bootloader receives the erase command message, when the ID contains the command
type (0x43) and the data field contains the sectors to be erased (see Table 9: STM8 sector
codes on page 49). A sector size is 1 Kbyte, therefore, the granularity with the erase
command is eight blocks (1 block = 128 bytes). If the host wants to erase one byte only, the
write command (write 0x00) can be used.
Erase memory command description
27/72
1.
The bootloader receives one byte which contains the number (N) of sectors to be
erased. N is device-dependent.
2.
Then, the bootloader receives (N + 1) bytes, where each byte contains a sector code
(see Table 9: STM8 sector codes on page 49).
DocID14798 Rev 9