Download Untitled - JazzMutant
Transcript
The Lemur User Manual Now change to the Behavior panel and activate the Physic checkbox. Also, change the tension to 0.1 and the friction to 0 . Now it’s a completely different story. If you move the sliders they will continue to wiggle forever. They behave as if they are connected with springs and oscillate around a centre value that’s defined by the height parameter. Object Again, we are only scratching the surface here. Please have a look at the Reference for details about all Object Properties. Let’s come back to our MultiBall Object. The Capture parameter on the Behavior panel has great influence on the possible finger actions. When you are inside of the Object’s boundaries the Capture mode doesn’t make any difference. But if you move the ball and leave the borders of the Object, the control of the ball will stop when Capture is off . If Capture is on , the ball will continue being tied to your actions. No matter if you move your finger across other Objects and even if you switch to a different Interface, the ball will still cling to your finger and the finger has no effect on other Objects. Just experiment a bit with the two modes and you will quickly get the hang of it. The MultiBall Object is a complex critter. It also sports an ADSR+H envelope for its brightness parameter that is accessible as a numerical value inside its z parameter. You might be familiar with envelopes from using synthesizers. They represent an easy way to produce defined parameter changes over time. The MultiBall ADSR acts just like it’s cousins from the synthesis world. When you touch the Lemur the bri ghtness of the ball will be faded in according to the Attack value, decay down to the sustain level and fade out with the release time when you lift your finger from the surface. Objects supporting ADSR envelopes (MultiBall and Pads for the time being) also have a hold parameter. Its effect is similar to a sustain pedal, freezing the object’s state as long as its value is 1. When set to 0, if has no effect. Interesting effects can be achieved when setting the hold parameter to an expr essi o n depe ndi ng o n ot her obj ects’ s tat e . We’ll cover such methods later on.