Download Internet and Data Connectivity Using Optical Fiber and RF Signal
Transcript
4.2.1 Modulation In telecommunications, modulation is the process of conveying a message signal, for example a digital bit stream or an analog audio signal, inside another signal that can be physically transmitted. Modulation of a sine waveform is used to transform a base band message signal to a pass band signal, for example a radio-frequency signal (RF signal). In radio communications, cable TV systems or the public switched telephone network for instance, electrical signals can only be transferred over a limited pass band frequency spectrum, with specific (non-zero) lower and upper cutoff frequencies. Modulating a sine wave carrier makes it possible to keep the frequency content of the transferred signal as close as possible to the centre frequency (typically the carrier frequency) of the pass band. When coupled with demodulation, this technique can be used to, among other things, transmit a signal through a channel which may be opaque to the base band frequency range (for instance, when sending a telephone signal through a fiber-optic strand) 4.2.2 Demodulation Demodulation is the act of extracting the original information-bearing signal from a modulated carrier wave. A demodulator is an electronic circuit (or computer program in a software defined radio) that is used to recover the information content from the modulated carrier wave. These terms are traditionally used in connection with radio receivers, but many other systems use many kinds of demodulators. Another common one is in a modem, which is a contraction of the terms modulator/demodulator. 4.2.3 Radio communication In order to receive radio signals an antenna must be used. However, since the antenna will pick up thousands of radio signals at a time, a radio tuner is necessary to tune in to a particular frequency (or frequency range). This is typically done via a resonator – in its simplest form, a circuit with a capacitor and an inductor forming a tuned circuit. Often the inductor or the capacitor of the tuned circuit is adjustable allowing the user to change the frequencies at which it resonates. The resonant frequency of a tuned circuit is given by the formula 18