Download Usfos getting started

Transcript
USFOS GETTING STARTED
9.2.3
9-7
FEM Model
The structure is modelled by 160 nodal points, and 455 elements. 20 elements are defined as nonstructural. 19 materials and 119 cross-sections are defined.
Modules or topside facilities are not modelled. No joint cans or brace stubs are modelled.
Piles guides are modelled by equivalent elements. The equivalent stiffness of the pile guides and
piles is computed and used. The wave load is modelled by equivalent hydrodynamic diameters.
Conductor guide frames and the conductor guide arrangement is simplified. Wave loads are
modelled by equivalent element diameters.
The launch runners are modelled as an integrated part of the launch legs A2 and A3.
Conductors are lumped together as tubular elements with appropriate drag diameter and inertia
diameter. Risers, caissons, J-tubes, boat bumpers, walkway and ladder are modelled as equivalent
elements. These elements are defined as non-structural in the USFOS analyses.
Soil-structure interaction is modelled by linear springs.
9.2.4
Traditional pushover, loads from WAJAC
One pushover analysis is carried out for each platform direction.
Gravity loads, buoyancy and operational loads are incremented up to characteristic (unfactored)
value. Then, environmental forces are applied incrementally until collapse.
The following events are identified for each loading direction:
1) Initial yielding, λY
2) First member failure (member buckling or tension yielding), λF
3) Ultimate collapse load, λULT
Table 9.2-4 summarizes the results of the pushover analyses. Load factors for characteristic
events in each loading direction are listed. These are relative load levels, referred to the
characteristic loading for each direction, ref Table 3.2.3.
Table 9.2-4Characteristic load levels (load factors), pushover analyses
Direction
N
λ
NW
W
SW
S
SE
E
NE
Y
λF
λULT
MARINTEK 2001