Download SX77 Series Advanced Process Controller

Transcript
SX77
4-07-2008
8:59
Pagina 59
7 - Programmed Setpoint
7
PROGRAMMED
SETPOINT
INTRODUCTION
When the Setpoint programmer
option is present, up to four programs are available.
MAIN CHARACTERISTICS
• 4 program, 16 segments
max/program
• start, stop, hold etc, commands from the keypad
• time base in seconds, minutes or hours
• continuous or up to 1…9999
time cycling of the program
• two digital outputs (OP3 and
OP4) related to the program.
• setting of the maximum
allowed deviation from the
Setpoint
7.1
PROGRAM STRUCTURE
The program consists of a
sequence of segments.
For each segment, it is specified:
• the Setpoint
to reach
#s.p.
always
• the duration
present
of the segment
#t.i.
The program consists of:
• 1 initial segment named O
• 1 end segment named f
• 1…14 normal segments
Initial segment - 0
Its main purpose is to define the
value the process variable has
to maintain before starting the
program.
Ramp
#s.p.==
#ti.==
Dwell
• the state of the OP3 output
#s.p.==
#ti.==
End segment - F
Its main purpose is to define the
value the process variable has
to maintain at the end of the program and until further changes
of Setpoint.
Normal segments - ===
These segments build up the
profile program. There are 3
types of segments:
#ti.==
#s.p.==
Step
#s.p.==
#ti.== = 0
s.p.
ti.
= Target Setpoint
=Duration
=Previous segment
=Current segmente
=Next segment
59