Download GMS User Manual - Seismic Systems
Transcript
GMSplus User Manual 26.09.2012 / V2.6 109 / 112 14.4. Open recorded miniSEED files in GeoDAS The system is recording miniSEED files (.MSD). For viewing such files, GeoDAS can be used. As the signal is stored inside the mini-seed file in counts, a scaling factor has to be applied when opening the data. If an Extended format of MiniSEED files is used (see the chapter 10.8.3), scaling factors are applied by GeoDAS automatically, and you may skip the information below. • Open GeoDAS • Open recorded mini-seed file from the menu File Æ Open… a EventError! Bookmark not defined. files are stored under: \\GeoDAS_DATA\Data\STATION_NAME Ringbuffer files are stored under: \\GeoDAS_DATA\DataStreams\STATION_NAME Testpulses are stored under: \\GeoDAS_DATA\Incoming\NNNNNN • When you open a ‘.MSD’ file with GeoDAS, the following dialog box for scaling factor appears Figure 73, GeoDAS miniSEED parameters • The values Physical unit and Counts per physical unit must be set for correct display data in GeoSIG software GeoDAS. The values can be found in the Table 20 or calculated as described in chapter 14.4.2. a Do not tick “Always use the current parameters by default” as it is better to be remembered that scale has to be defined manually for such file type. • Press OK • If instead of the scale prompt you get directly the graph, use menu: Analyse Æ Parameters… Æ Parameters of miniSEED files and press Edit: Figure 74, GeoDAS analyses parameters • Now the dialog box for scaling factor should be seen. Enter the correct values, close and reopen the file you want to see. You will be prompted again for scale, just press Ok as the scale is now correct. GS_GMSplus_UserManual_V02.doc