Download OneCommand NIC Teaming and VLAN Manager

Transcript
Showing VLAN IDs
Syntax:
show vlans <team-id | adapter-id>
Description: This command shows a listing of VLAN IDs that are currently in use and those that are
available for use.
Parameters:
Adapter id - Adapter alias assigned by OCTeamCMD
Team-id - The name assigned to a team when it is created.
Example:
Creating a Team
Caution: Creating an adapter may take several minutes. Prematurely cancelling this
operation may result in partial removal of a team or VLAN, which may lead to
future teaming issues including system instability.
Note: If you are creating a failover team when one already exists, you must reboot the
system before the newly created failover team is capable of failing over. You can
continue to create additional teams before rebooting however.
Syntax:
create team <failover:<auto-failback-setting> |
| LACP:<hash> > team-name adapter-list
loadbalance:<hash> |
802.3ad:<hash>
Description: This command creates a team. The team-name is the name for the team that is to be
created. The name cannot exceed 80 characters and must be unique. The adapters listed as part of the
team may not be part of another team and may not have VLANs assigned to them. The first adapter
listed becomes the primary adapter; this must be an Emulex adapter. The number of allowable team
members varies with team type. Failover teams must have 2 members. Load balancing teams must
have from 2 to 8 members. LACP and 802.3ad teams must have from 2 to 4 members. The autofailback-setting is only used for failover teams. This setting specifies whether the team should
automatically resume using the primary adapter once it becomes available again after the team has
failed over to the secondary adapter.
A maximum of 4 teams can be created. Use the abbreviated names from Table 2 when specifying the
team type on Load Balancing, LACP and 802.3ad teams from the command line.
OneCommand NIC Teaming and VLAN Manager User Manual
Page 37