Download Ford Lehman

Transcript
A30
Romov© air Mtor(s) ond covor openings In manifold with plastic film hold in ploco with masking topo. Sool off all
othor openings . . . air vont on top of rockor arm covor, vorjt on front ond of sump and overflow and vont hole,on
Injection pump. Plug exhaust pipe to prevent entrance of moisture.
Make certain that all engine exterior surfaces are clean, dry and free of oil or grease; then spray complete onglno
with any good rust preventative compound.
"
k
Before restarting englno, romovo all plastic seals, covers, oxhaust plug, etc., and refit air flltor(s) in placo. Do not
neglect to replace all drain plugs, tighten roar covor of row wator pump, and turn on seacock.
Galley Hot Water Connections
It is common marine practice to utilize onglno coolant passed through a hot water heater to provide domestic hot
wator. Connection to englno Is mado with Lohman Kit 01496. A coolant food to the heater Is made from the onglno
drain plug on tho portsldo of block while tho coolant roturn hoso is attached to tho forward, port side of the exhaust
manifold. Always ensure that tho max. height of tho cooling hot water coil Is r lower than tho top angle of tho
expansion tank.