Download ESP7000 Motion Controller/Driver

Transcript
GR
set master-slave reduction ratio
USAGE
IMM
♦
SYNTAX
xxGRnn or xxGR?
PARAMETERS
Description
Range
Units
Defaults
DESCRIPTION
PGM MIP
♦
♦
xx [ int ]
nn [ float ]
-
axis number
reduction ratio
xx
nn
xx
nn
-
1 to MAX AXES
±1,000,000
none
none
xx
missing:
out of range:
nn
missing:
out of range:
error 37, AXIS NUMBER MISSING
error 9, AXIS NUMBER OUT OF RANGE
error 38, COMMAND PARAMETER MISSING
error xx2, PARAMETER OUT OF RANGE
This command sets the master-slave reduction ratio for a slave axis. The
trajectory of the slave is the desired trajectory or actual position of the master
scaled by reduction ratio. Refer to the TJ command to specify the desired
trajectory mode for a slave axis.
Note:
Use this command very carefully. The slave axis will have its speed and
acceleration in the same ratio as the position. Also, ensure that the ratio used for
the slave axis does not cause overflow of this axis’ parameters (speed,
acceleration), especially with ratios greater than 1.
RETURNS
If “?” sign is issued along with command, the controller returns master-slave
reduction ratio.
REL. COMMANDS
SS
EXAMPLE
2SS1
2SS?
1
2TJ5
2GR0.5
2GR?
0.5
Section 3 – Remote Mode
-
define master-slave relationship
| set axis 2 to be the slave of axis 1
| query the master axis number for axis 2
| controller returns a value of 1
| set axis 2 trajectory mode to 5
| set the reduction ratio of axis 2 to 0.5
| query the reduction ratio of axis 2
| controller returns a value of 0.5
3-67