Download CNC Cutting Controller CC

Transcript
10.3.5 Plasma cutting conneciton (next page)
10.3.6 Flame/plasma integration
If flame/plasma integration is used, beside the above
connection, a change switch K1 of flame/plasma is
needed, connection as below,
(1) KR acetylene (gas) magnetic valve
(2) kQ cutting oxygen magnetic valve
(3) If not connect acetylene (gas) magnetic valve, it's OK
not to connect gas contact point
(4) K1 is a relay (M20) of flame/plasma change-over
10.4 Output connection
10.4.1 Output principle
page: 32
SaleCNC Website http://www.salecnc.com