Download Xilinx Command Line Tools User Guide

Transcript
Chapter 24: NGCBuild
-i (Ignore UCF File)
This option tells NGDBuild to ignore the UCF file. Without this option NGDBuild reads the constraints in the
UCF file automatically if the UCF file in the top-level design netlist directory has the same base name as the
input design file and a .ucf extension.
Syntax
-i
Note If you use this option, do not use the -uc option.
-insert_keep_hierarchy (Insert KEEP_HIERARCHY constraint)
This option automatically attaches the KEEP_HIERARCHY constraint to each input netlist. It should only
be used when performing a bottom-up synthesis flow, where separate netlists are created for each piece of
hierarchy. When using this option you should use good design practices as described in the Synthesis and
Simulation Design Guide.
Syntax
-insert_keep_hierarchy
Note Care should be taken when trying to use this option with Cores, as they may not be coded for maintaining
hierarchy.
-intstyle (Integration Style)
This option limits screen output, based on the integration style that you are running, to warning and error
messages only.
Syntax
-intstyle {ise | xflow | silent}
When using -intstyle, one of three modes must be specified:
•
-intstyle ise indicates the program is being run as part of an integrated design environment.
•
-intstyle xflow indicates the program is being run as part of an integrated batch flow.
•
-intstyle silent limits screen output to warning and error messages only.
Note -intstyle is automatically invoked when running in an integrated environment such as Project
Navigator or XFLOW.
-ise (ISE Project File)
This option specifies an ISE® project file, which can contain partition information and settings to capture and
filter messages produced by the program during execution.
Syntax
-ise project_file
-nt (Netlist Translation Type)
This option determines how timestamps are treated by the Netlist Launcher when it is invoked by NGDBuild. A
timestamp is information in a file that indicates the date and time the file was created.
288
www.xilinx.com
Command Line Tools User Guide
UG628 (v 11.4) December 2, 2009