Download RU Builder User Manual

Transcript
9 Exported configuration parameters
User Manual
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
RU Builder
The default values of the BU control parameters were calculated as follows:
To prevent a BU from monopolizing event ids, each BU has a maximum number of event ids it
can acquire at any moment in time. Assuming all BUs are equal, each BU is allowed to acquire:
rubuilder::bu::Application::maxEvtsUnderConstruction
= nbEvtIdsInBuilder / number of BUs
= 4096 / 64
= 64
The blockFIFO of a BU (see figure 2 in section 3.2) is responsible for buffering incoming event
data. In the worst case this FIFO would have to buffer the blocks of all outstanding requests for
event data:
rubuilder::bu::Application::blockFIFOCapacity
= maxEvtIdsUnderConstruction × size of an event / block size
= 64 × 1 MB / 4 KB
= 64 ×256
= 16384
A BU has a single FIFO called discardFIFO for FU discard messages, and one FIFO per FU called
requestFIFO for FU request messages. Knowing that a BU can service a maximum of 64 FUs and
assuming that a single FU will never have more than 1024 outstanding requests for events:
rubuilder::bu::Application::discardFIFOCapacity
= 1024 × maximum number of FUs
= 1024 × 64
= 65536
rubuilder::bu::Application::requestFIFOCapacity
= 1024
The default values of the RU exported parameters were calculated as follows:
The blockFIFO of the RU is responsible for buffering incoming super-fragment data. Assuming a
RUI only gives as many super-fragments to a RU as the TA gives triggers to the EVM, then in the
worst case the blockFIFO must hold the blocks of as many super-fragments as there are event ids
in the RU builder:
rubuilder::ru::Application::blockFIFOCapacity
= nbEvtIdsInBuilder × (size of a super-fragment / block size)
= 4096 × (16K / 4KB)
= 16384
The parameters of the form _Packing should not normally be modified as they have only been tested
with the default value of 8. However the user may modify them if they are experiencing performance
problems with the RU builder.
45
CERN PH/CMD - 2008
Page 35 of 54