Download User`s Manual

Transcript
BusFeeder Instruction Manual
Nodes and midpoints are useful for editing shapes. The midpoints allow you to modify a
section of a shape between two points without having to manually insert changes. In
addition, when a midpoint is moved to create a new point, it also creates two new
midpoints: one between the new point and the other points on either side. The new
midpoints can then also be moved to create more shape points and add further detail to
your shape.
Note that changes you make to your shape are not recorded until you click the
button.
Add to Shape: You may add new points to the end of a shape by clicking the
button. When adding to a shape, you may click on the map to add a new point. The map
display will show a dotted line (see image below) between the last point of the shape and
where the cursor is placed. Once clicked, a solid line will appear, and the new point will
be displayed as a node. BusFeeder will automatically add the new point in sequence to
the existing shape. Add to Shape is only for adding points to the end of a shape. If you
want to add points to the middle of a shape, you may manually enter them, or click and
drag on the shaded nodes to convert them to points in the shape.
Note that changes you make to your shape are not recorded until you click the
button. Once a point is added, you may edit its location using the “Edit
Shape” function.
Important Notes about Shapes:
1. A shape must have at least one point within 20 meters (approximately 65 feet) of
the stops used in the trip(s) the shape will depict. Use the shaded bubble around
stops as your guide. This is a Google requirement so that Google can correctly
represent a user’s itinerary from his or her starting stop to the ending stop.
2. Shapes can be depicted at the centerline of the paths the vehicles will travel on, or
to one side or the other of the centerline, so long as a shape point is within 20
-41-