Download User Manual

Transcript
M A G M A
c.
Now go into y our host computer and change the IP address to be
192.168.10.5 and set the gateway to 192.168.10.1
10. Go back to the homepage of the SNMP unit using the
192.168.10.100 addr ess, password: magma
11. Remov e one f an at a time (as shown in the Fan Replacement
section). After remov ing each one hit the clear alarm button to turn
off the alarm signal and ref resh the homepage to make sure the
f ans correspond to the proper position i.e. fan 1 of the homepage
corresponds to f an 1 on the chassis. Also check the LED board to
make sure that the corresponding LED turned orange. It should turn
green once the f an is plugged back in automatically .
12. Repeat step 9 f or f ans 2, 3, 4 and power supply 1 and 2 which hav e
an off button on the rear left side of the chassis.
Powe r Supply 1 is the one located on top while Power Su pply 2 is
on the bottom.
36