Download inpO2 User Manual
Transcript
130 • User Manual • In the Layout Manager window, click on the first tool icon to add a Press Run for job ganging. • Set the Press Run parameters in the upper-right panel. Select Presets for the Press, Paper, and Finishing Method that will be used. • Observe the checkpoints in the lower-right section. The compatibility of selected components is validated each time a new selection is done. Do not spend too much time adjusting them as all these settings may change later. • The goal is to obtain the most optimized layout scenario by changing production components. Press Run parameters can thus be changed later after Product Parts are defined. • Once the Press Run (Ganging) is defined, you can either load documents to create Product Parts, or insert empty Product Parts. Either way will produce Product Parts nodes in the Press Run. • Set the parameters of each Product Parts in the upper-right panel, if required. The requested quantity is a very important data for the optimization, especially if it is different for each Product Part. • As soon as Product Parts are defined, the resulting layout can be validated on the light table. • At this point, if the checkpoints are still showing errors, it is important that they be resolved. Each error and warning item in the list can be expanded to see details of the problem. Thus it should be relatively easy to figure out a solution. Tips for Optimization Prepare the work space to have a good preview of the resulting layout. • In the inpO2 Profiles dialogue, customize the working profile to display Product Part Names as well as Product Part Colors. This will help to identify the different Product Parts on the light table. • Activate the Pages panel on the left side of Acrobat’s window to see thumbnails. Thumbnails can also be enlarged from the Options menu. Know these simple rules to achieve the best optimization. • Enter the largest product first and continue with smaller ones. If the sheet is already filled with smaller products, larger products will have no place to fit, but if the larger product is placed, smaller ones will flow around it to fill remaining spaces. • When possible, try Product Parts to follow alternate grain orientation, or to be placed on either grain orientation to give more flexibility for the positioning. • A Product Part in the Press Run can be prioritized for a placement near the gutter edge for best printing quality. • Product Parts can share a bleed side to save cuts and paper. • When managing too many Product Parts, it may be necessary to add another Press Run and distribute the Product Parts among Press Runs for a better usage ratio. Release: November 20, 2012