Download Contact Digitizer:

Transcript
THE TOOLKIT
Adjustments Tab
Lateral Arch Support - This adjustment allows the operator to reduce or increase
the amount of support under the lateral arch area. This adjustment is specified
by a percentage. Possible range: -30% to +30%.
Total Support - Reduce or increase the amount of support across the entire
area. Example: If an area under the foot measures 20 mm and the Total Support
is set to +10%, the mill cuts that area at 22 mm above the minimum orthotic
thickness.
Medial Arch Support - This adjustment allows operator to reduce or increase
the amount of support under the medial arch area. This adjustment is specified
by a percentage. Possible range: -30% to +30%.
Heel Cupping - Allows the operator to reduce or increase the amount of support
around the heel area. Example: If an area around the heel measures 20 mm
and the Heel Cupping is set to +10%, the mill cuts that area at 22 mm above the
minimum orthotic thickness and the Heel Lift. Possible range: -30% to +30%.
Page 68