Download Program Tutorial

Transcript
Program Tutorial - Further Measurements
Here it becomes obvious that the integral contains all of the noise as well. To reduce the effect of
noise in the RT calculation, there is a function called NOISE COMP in SysTune. Enable the noise
compensation with the NOISE COMP switch in the DISPLAY panel of the ETC graph. After that the
Schroeder curve will look much better, as shown below.
For typical cases, it should look like a smooth envelope of the ETC curve. In the late part of it,
for higher times, it should show gaps as shown above where the noise is subtracted correctly
from the original integral. But if the curve is still too flat (as first shown above, without noise
compensation) or too much energy is removed (the gaps occur very early in time), then you will
need an advanced software tool to calculate the RT manually. To verify the noise prediction, you
can also compare the noise value computed by the software with the ETC graph. It is shown
directly below the switch NOISE COMP.
131