Download 5.93MB

Transcript
MKY44-MC02A User's Manual
1.3.4 Timing to Receive Move Instructions
The basic instructions Stop and Deceleration Stop will be received even while operating with move instructions
(Peak Keep Time may be inserted into the Deceleration Stop instruction with the triangular drive prevention
function).
In contrast, move instructions will be received only while stopped. While logical position coordinates are
transitioning, move instructions will not be received since the initial position for movement can hardly be
identified. If the user application mistakenly issues a move instruction during operation, MKY44-MC02A will
return an error saying that it will not receive the instruction.
1.3.5 Operation of Move Instructions to Maintain Constant Speed
Among the move instructions, the following four instructions move with constant speed.
1. Distance specification lower speed movement (DS_LFlat)
The part corresponding to the graphical area
of these speed transitions is the distance. For
3. Target specification lower speed movement (TS_LFlat)
example, the movement time required for a
4. Target specification upper speed movement (TS_UFlat)
“distance specification lower speed
movement (DS_LFlat)” instruction when the
lower speed is “1,000 pps” and the relative distance is “10,000” is “10 seconds” [10,000 ÷ 1,000]. The
movement time required for a “distance specification upper speed movement (DS_UFlat)” instruction when the
upper speed is “5,000 pss” and the relative distance is “10,000” is “2 seconds”. The distance in both cases is
“10,000” and the area of the diagram is also the same. Also, the distance matches the pulse count output by the
pulse output pin of MKY44-MC02A (see Figure 1.12).
2. Distance specification upper speed movement (DS_UFlat)
Fig. 1.12 Move Instructions to Maintain Constant Speed
1-16