Download smartmeter S1 - Smart Electronic

Transcript
Menu DiSEqC Motor Search
10 Menu DiSEqC Motor Search
This menu is used to set up a motor antenna and its control system.
In all menu windows (e. g. moving dish) you see signal strength S and signal quality Q.
1. In TV mode press the MENU key (or
navigate to main menu).
2. Select with the keys ◄/► and ▲/▼ the
sub menu DiSEqC Motor Search and
confirm with OK.
 Press the blue function key to turn the satellite dish to the west.
 Press the yellow function key to turn the satellite dish to the east.
 Press the green function key to start a channel search for the current transponder (see
section 6.7 „Searching Channels“). Since you use DiSEqC1.2 or USALS for the antenna
control, normally you can ignore the lines DiSEqC1.0 and DiSEqC1.1. There are special
cases (e. g. cascading of DiSEqC switches) where additionally to DiSEqC1.2 you need
DiSEqC1.1.
 Press the red function key to set the
details for the motor control:
 Select at Satellite with the keys ◄
and ► the satellite for the following
settings should be valid.
 Select Transponder to set the transponder which should be reference for the antenna position (generally the transponder which broadcasts your favorite channel).
 Select Motor Type to set the used control technique. Select between DiSEqC1.2
and USALS (depending on the used motor). Depending on your choice, different settings are available.
10.1
DiSEqC 1.2
 Select Position No & Save to set a position number as which the current satellite (the
current antenna position) will be saved.
22
smartmeter S1