Download DAPM6802+ Dual Audio Processing Module Installation and

Transcript
APM6802+
Installation and Operation Manual
39
Examples
The following is an example of correct syntax:
IF GPI1==0 THEN PARAM[34]=0
The table below illustrates errors in syntax and how errors are reported.
Table 5-1 Error Reporting
Incorrect Command
Status
Comments
IF GPI1=0 THEN PARAM[34]=0
Error:7
“==” must be used in comparison commands.
“=” is incorrect.
IF GPI1==0 THEN PARAM[34]==0
Error:28
“=” must be used in assignment commands.
“==” is incorrect.
IF GPI1==0 THEN PARAM [34]=0
Error:16
There must be no space between “PARAM” and “[“
IF GPI1==0 THEN pARAM[34]=0
Error:16
PARAM must be in all caps.
pARAM is incorrect.
IF GpI1==0 THEN PARRAM[34]=0
Error:3
There are 2 errors in this command - GpI is not in all caps
and PARRAM has been misspelled. However, only the index
of the first error found is reported.
Custom GPI Scripts
The DAPM6802+ supports custom GPI scripts to enable you to configure GPIs. Refer
Common Scripting Guidelines for more details on writing your GPI script.
GPI scripting is available by going to:
Parameters > General > Custom GPI
Figure 5-1 Custom GPI Script Settings
Copyright © 2012, Harris Corporation