Download Weld334m

Transcript
Technical Manual
P43 . Functional description of the input signals
Pin Signal
Function
11
12
13
14
15
16
CODE0
CODE1
CODE2
CODE3
CODE4
CODE5
Active at +24V.
Inputs dedicated to selection (in binary code) of the welding program to be run
at Start.
When Start is active, the control runs the program corresponding to the binary
code read (see code table on page 38).
Up to 64 welding programs can be used.
NB: To select program 64, all the inputs of the program code must be at logical
0V.
17
CODEP
Parity code.
Active at +24V.
Used only on robotized lines.
Is used for logical checking of the CODE0....5 inputs and depends on the setting
in the Setup menu.
(see code table on page 38).
Warning! If it is not used, it must be disabled (see Setup programming
manual).
18
CONSALD
Welding consent.
Input active a +24V.
The welding consent is the weld enable signal; it indicates that the welding
machine is ready; the welding control waits for this signal after it has sent the
RICHSALD signal.
The control waits until the consent signal is received
Card layout: standard configuration of the jumpers
J1: 2-3
JP1: Off
37