Download Rev 2.0xf
Transcript
5. Set the Address DIP Switches as described above. Note that the dip switch is marked with an ‘On’ marking. In this case, ON=0 and OFF=1. Example: See following illustration. A2 0 1 A3 A4 A5 A6 A7 -------ON------- A8 0 1 To simplify this task, we have included a complete list of DIP switch settings corresponding to all configurable addresses between 512 and 1024. This is in the table entitled “Dip Switch Address Settings” in Appendix A. In addition, two DOS programs which calculate the dip settings are provided on the COMMDISK VOL1: ADDRCALC.EXE, and PIN_CALC.EXE: To use ADDRCALC, type ADDRCALC at the C:/COMMDISK> and enter a decimal address. The program will return the DIP switch setting (note that when the program refers to a switch as “jumpered” it means the switch is set in the ON or 0 position, and when the program refers to a switch as “open” it means the switch is set in the OFF or 1 position). The PIN_CALC program prompts the user for individual switch settings and returns the corresponding decimal address. Step B. Configuring Address for Communications Software Once you have configured the Address DIP Switches on the DMC-1000, the controller software must be configured to communicate to this address. The procedure for address configuration depends on the communication software being used. Galil has 4 software packages that can communicate with Galil Motion Controllers; COMMDISK, SDK-1000 (DOS-based Servo Design Kit for the DMC1000), WSDK16 (Windows 3.x 16-bit version of the Servo Design Kit, and WSDK32 (Windows 95 and NT 32-bit version of the Servo Design Kit). Step 6. Connect Amplifiers and Encoders. Once you have established communications between the software and the DMC-1000, you are ready to connect the rest of the motion control system. The motion control system typically consists of an ICM-1100 Interface Module, an amplifier for each axis of motion, and a motor to transform the current from the amplifier into torque for motion. Galil also offers the AMP-11X0 series Interface Modules which are ICM-1100’s equipped with servo amplifiers for brush type DC motors. If you are using an ICM-1100, connect the 100-pin ribbon cable to the DMC-1000 and to the connector located on the AMP-11X0 or ICM-1100 board. The ICM-1100 provides screw terminals for access to the connections described in the following discussion. 1080 Motion Controllers with more than 4 axes require a second ICM-1100 or AMP-11X0 and second 100pin cable. System connection procedures will depend on system components and motor types. Any combination of motor types can be used with the DMC-1000. Here are the first steps for connecting a motion control system: Step A. Connect the motor to the amplifier with no connection to the controller. Consult the amplifier documentation for instructions regarding proper connections. Connect and turn-on the amplifier power supply. If the amplifiers are operating properly, the motor should stand still even when the amplifiers are powered up. DMC-1000 Chapter 2 Getting Started • 11