Download fulltext - DiVA Portal

Transcript
8 CONCLUSIONS
The work conducted in this thesis has shown that it is possible to apply structural methods to
RODON models. It has also shown that even a prototype implementation can handle quite large
systems. Some problems have also been found during the project.
Extracting a structural model from RODON models is not a straightforward process. This is
due to the ability of RODON to handle under-, just- and over-constrained models. Therefore the
implemented prototype only works for a small subset of especially rudimentary models in the
modeling library. Spending more time on the task can certainly increase this subset. It can
probably make it sufficiently large to make structural methods useful in RODON. However, it
will likely be difficult to extend the subset to the set of all possible RODON models, due to the
freedom of the modeler in Rodelica.
The implemented algorithm can handle reasonably big systems as long as redundancy is low.
The prototype performance has good potential for improvements, most notably in the
algorithm to find the overconstrained part of a model. Improving this part will have great
impact on execution speed. It can also extend the valid input set.
The main use of structural methods considered here has been to find suitable residuals to
create diagnostic tests. However other uses of structural methods have been investigated as
well. Many of these can be used in RODON if a structural model can be extracted successfully.
For example optimal sensor placement can be of interest in RODON.
37