Download Programmer`s Reference Manual

Transcript
Chapter
2
Configuring the LQ-1600K Emulation with Control Codes
Select Bit Image
ASCII Code SSCC *
m nL
nH d1...dk
Hex Code
SSCC 2A m nL
nH d1...dk
Dec Code
SSCC 42 m nL
nH d1...dk
Purpose
Prints dot graphics in 12- or 16-dot columns, depending on the
following parameters:
Where:
0 < = nL < = 255
0 < = nH < = 31
m = 30, 31, 32
m specifies the dot density.
nL nH specifies the total number of columns of graphics data
that follow (number of dot columns) = (nH x 256 + nL)
d1...dk bytes of graphics data; k is determined by multiplying
the total number of columns times the number of bytes required
for each column.
Parameter
m in ESC *
Horizontal
Density (dpi)
Vertical
Density (dpi)
Dots per
Column
Bytes per
Column
30
90
90
12
2
31
120
120
16
2
32
90
90
16
2
Select DBCS ASCII Character Type
ASCII Code FS
k
n
Hex Code
1C
6B n
Dec Code
28
107 n
Purpose
This selects a DBCS ASCII character:
n = 0 or 40 Selects normal DBCS ASCII characters
n = 1 or 49 Selects oversized DBCS ASCII characters.
Where
n = 0, 1, 48, 49
The default is n = 0, normal DBCS ASCII character.
Comment
70
This command affects the front panel setting of “DBCS ASCII
Style.”