Download the AOMix manual

Transcript
Updated on July 23, 2015
Dr. S. I. Gorelsky, AOMix manual (www.sg-chem.net)
Practical Recommendations
Electron population analysis and the related concepts (bond orders, valence indices, etc.) are
extremely useful for the wave function analysis. However, one has to remember that
1. Resulting quantities are not quantum mechanical observables;
2. Results are dependent on the quality of the basis set. What makes this dependence
problematic is that the improvement in basis set (resulting in lowing of the total electronic
energy) can make results of the population analysis (MPA in particular) worse or even
completely unrealistic.
My experience with different basis sets shows that basis sets, such as 6-31G*, 6-311G*, TZV,
and TZVP, do not usually cause failures in calculations of MPA-derived MO compositions, CDA,
and bond orders. However, basis sets with very diffuse functions (such as 6-311+G*) may cause
unrealistic results.
The indicators of this problem are:
1. negative MO contributions from fragments (in the MO composition analysis using MPA
or MMPA);
2. MO contributions from fragments that are greater than 100% (in the MO composition
analysis using MPA or MMPA);
3. negative partial DOS values;
4. large negative charge donation and back-donation values between fragments (using
CDA); and
5. large negative 2-center bond order indices.
If you encounter any of the above and your basis set contains diffuse functions, you will need to
77
check your population results with a well behaving basis set. The TZVP basis set
is
recommended for population analysis calculations. It is a high-quality basis set with enough
flexibility to produce accurate results for structures, thermochemistry, and electronic structure
78
analysis. As a more economic alternative, the DZVP basis set can be used.
When you run AOMix-FO calculations, it is important to remember about the basis set
79
superposition error (BSSE) effects.
Usually, the BSSE is discussed for calculations of energies of formations, but it is also
relevant for construction of MO-FO interaction diagrams. It is clear that the BSSE is expected to
be particularly significant when small, inadequate basis sets are used. These do not provide an
82