Download User Manual - Galil Motion Control
Transcript
value of the step count register as well as the value of the reference position. For example, DP 0, defines the reference position of the X axis to be zero. Stepper Smoothing Filter (Adds a Delay) Motion Profiler Reference Position (RP) Output (To Stepper Driver) Output Buffer Step Count Register (TD) Motion Complete Trippoint When used in stepper mode, the MC command will hold up execution of the proceeding commands until the controller has generated the same number of steps out of the step count register as specified in the commanded position. The MC trippoint (Motion Complete) is generally more useful than AM trippoint (After Motion) since the step pulses can be delayed from the commanded position due to stepper motor smoothing. Using an Encoder with Stepper Motors An encoder may be used on a stepper motor to check the actual motor position with the commanded position. If an encoder is used, it must be connected to the main encoder input. Note: The auxiliary encoder is not available while operating with stepper motors. The position of the encoder can be interrogated by using the command, TP. The position value can be defined by using the command, DE. Note: Closed loop operation with a stepper motor is not possible. Command Summary - Stepper Motor Operation COMMAND DESCRIPTION DE Define Encoder Position (When using an encoder) DP Define Reference Position and Step Count Register IT Motion Profile Smoothing - Independent Time Constant KS Stepper Motor Smoothing MT Motor Type (2,-2,2.5 or -2.5 for stepper motors) RP Report Commanded Position TD Report number of step pulses generated by controller TP Tell Position of Encoder Operand Summary - Stepper Motor Operation OPERAND DESCRIPTION _DEx Contains the value of the step count register for the ‘x’ axis _DPx Contains the value of the main encoder for the ‘x’ axis _ITx Contains the value of the Independent Time constant for the ‘x’ axis _KSx Contains the value of the Stepper Motor Smoothing Constant for the ‘x’ axis _MTx Contains the motor type value for the ‘x’ axis _RPx Contains the commanded position generated by the profiler for the ‘x’ axis _TDx Contains the value of the step count register for the ‘x’ axis _TPx Contains the value of the main encoder for the ‘x’ axis 118 • Chapter 6 Programming Motion DMC-1700/1800