Download Gas Clean Filter System User Guide

Transcript
Using the Gas Clean Filter System
7 Install the connecting unit to the wall mounting bracket.
a Depending on the inlet/outlet fitting orientation on the
connecting unit, align the connecting unit to the
bracket as shown in Figure 9.
Figure 9
Connecting unit orientations on wall mounting bracket
b Using your hand, install the hex screws from the
bottom- up until they are finger tight (Figure 10).
Figure 10 Hex screws installed
c Use a 4- mm hex wrench to tighten the screws. The
connecting unit should be tight against the wall
mounting bracket.
User Guide
19