Download Users Manual - About Projectors
Transcript
LBV00056; Revision A - 23/08/99 System Operation Palm Pilot Control Utility Operation The Palm Pilot Control Utility has been designed to allow extensive operational control of the projector without using the on-screen menu system. The Palm Pilot connects to the projectors computer port via a straight wired 9 pin male to female cable and uses the following settings - 19,200 baud, 8 bits, no parity, 1 stop bit, no flow control. Upon selection of a projector, the utility will establish a connection with the projector and the Main Screen will appear providing the main controls - Chan, Lamp, PMute, Addr, Quit, Query, Pic adj and Geo Adj. Chan - allows you to directly select a projector channel. To select channels one through nine the corresponding button should be used. To select channels 10 and above, first press 10+ then the sequence for the required channel. The current channel (or the status of the channel change) will be displayed above the channel selection buttons. Lamp - sets the lamp power to high, low or off. The current setting will be displayed above the lamp power buttons. PMute - sets the picture muting. The current setting will be displayed. Addr - allows you to define the projector address you want to control when using multiple projectors. It is only possible to query one projector at a time with the Palm Pilot program and the addresses of the individual projectors must be pre-defined before they can be controlled. If you define an address of 0 with multiple projectors connected, your return values will be invalid. CÑ55 OPERATION Assuming the connection to the projector is set up correctly, when you activate the Power Control Utility the Function screen will be displayed. This screen allows selection between control of DV Series or GV Series projectors or to use the Lens and Lumen Calculation functions.