Download C 2 Owner`s Guide

Transcript
20
USING THE MASTER AND SIDEKICK REMOTES continued
Even when the remotes are customized, however, the printed buttons will usually have the
following functions:
Previous
Channel
Guide
Channel
Selection
Menu
Players &
Recorders
Favorite
Numerical
Keypad
•
•
•
•
•
•
The buttons surrounding the Master remote’s thumbpad are labeled for use as transport controls for DVD players, VCRs, tape decks, etc., and will ordinarily be used as such, controlling
whichever device’s control pages are active.
MENU, if pressed while any of the C1/C2 pages is on the display, will put the C 2 in setup
mode, as described in the chapter on “Adjustments, Menus, and Setup,” pages 22-35.
CH + and CH – can be programmed to change channels on whatever device or devices you use
for station selection. If, for example, you used both a satellite-dish tuner and a cable tuner,
these buttons could control channel selection for whichever one was currently shown on the
Master remote’s display, and control station selection when the current device was your
FM/AM tuner. You might, however, find it more convenient, if you have only one tunable device,
to program these buttons to tune that device at all times, no matter what device is shown on
the remote’s display.
PREV CH recalls the last cable or satellite channel you were watching, as long as your cable or
satellite tuner supports this function.
GUIDE commonly displays your satellite or cable company’s program guide.
The numerical keypad can be used for channel selection, time setting on VCRs, direct frequency
entry for tuning some FM/AM tuners, and so on. Not all its buttons will necessarily be used; for
example, some TV tuners require the use of a +10 key when tuning to channels 11 and higher,
or the use of an ENT (Enter) button for tuning to channel numbers with fewer than two or three
digits, but others do not.