Download Process-Pascal Version 4 Users Manual - Proces-Data
Transcript
502 052 02 15 Buffer A buffer is considered as a FIFO (First In First Out), where elements are placed in the end of a queue when a variable is assigned to the buffer, and the elements are removed from the front of the queue, when the buffer is assigned to a variable. When operating with buffers, the inserting and removing of elements, considers the entire element. This means that if the element type is a structured type, you can not access a specific field directly in the buffer. Instead you must assign the whole element to a variable of the same type and then access the particular field in that variable. Buffers have a fixed number of elements of one type, the element type. The element type can be of any type except a BUFFER type and a TIMER type. The syntax for a buffer type is: The constant denotes the buffer size, the max. number of elements in the buffer. When an element is read out from a buffer, it is deleted from the buffer and cannot be read out again. Buffers must always be initiated before they are used the first time. This is done with the standard procedure InitBuffer(buffername). Before a variable is assigned to a buffer, the program must check if the buffer is full. This is done with BufferFull(buffername) which is a standard function. The function returns a boolean, TRUE if the buffer is full. If a variable is assigned to a buffer and the buffer is already full, an error is produced and the value will not be stored into the buffer, until an element has been removed from the buffer. Before a buffer is assigned to a variable, the program must check if the buffer is empty. This is done with BufferEmpty(buffername) which is also a standard function. The function returns a boolean, TRUE if the buffer is empty. If an empty buffer is assigned to a variable, an error is produced and the variable will not be assigned until an element has been inserted in the buffer. If a variable of the type BUFFER is a component of a complex variable, the buffer component variable is only to be used internally in the controller. (P-NET restriction). Manual Process-Pascal 4.0 37/141