Download Appendix D: LabVIEW™ Tutorial

Transcript
Appendix D
878
laamim^Mtmnn*™^
LabVIEW Tutorial
•
*" Configure Simulation Parameters
E
Simulation Parameters | Timing Parameters
Simula bon Parameters
Enable Synchronized Timing
Simulation Time
0 Synchronize Loop to Timing Source
RrtalTime(s)
Initial Time (s)
Timing Source
Source type
Solver Method
00E Solver
[Runge-Kutta 4
1 kHz <resetat structure start>
1MHz <reset at structu/e Mart
51 - ' B n ;e to Scan EhtfM
Other <defined by source name or terminal >
DNan/Inf Check
Continuous Time Step a n d Tolerance
Source name
1kHz
to
0.01
Mawnum Step Size (s)
Loop Timing Attributes
Period
ilE-10
•
j
0.001
Offset/Phase
'lE-7
Auto Period
Priority
[too
Deadline
Discrete Time S t e p
1
Timeout (ms)
Discrete Step Size (s)
fo.i
0 Auto Discrete Time
'm
Processor Assignment
Mode
j Automatic
OK
OX
(a)
FIGURE D.19
v1
Cancel
m
Configuring the Simulation Loop parameters: a. Simulation parameters; b. Timing parameters
Example D.6
Effect of Amplifier Saturation on Motor's Load Angular Velocity
Create Block Diagram and Front Panel The Block Diagram and Front Panel for
simulating a dc motor with and without saturation are shown in Figure D.20. The
Saturation block is obtained from Control Design & Simulation/Simulation/Nonliner Systems/Saturation.
Satuabon
Transfer Kntbon
1ST
avtia&onTWWavpform IWBv^c^Oyti
Transfer Function 2
(a)
FIGURE D.20 Simulation of a dc motor with and without saturation: a. Block Diagram; (figure continues)