Download DOG20

Transcript
2.4.6 Host connection - DOG20 terminal via dial-up modem
For connection 1 standard modem cable should be used. Connection 2
should be wired according to the following table.
DOG20
2
Modem, DB25F connector
Block - Signal name)
(Pin - Signal name)
K7 - GND
Wire 1
7 -Signal GND
K7 - RXA
Wire 2
3 - RXD
Wire 3
2 - TXD
Shield
1 - Frame GND
K7 - TXA
4 (RTS) - 5 (CTS)
Bridge on connector
6 (DSR) - 20 (DTR)
Bridge on connector
Note: Remote modem should be preset for Auto Answer mode and its
DTE speed should be preset according to DOG20 host line baud rate
before the operation.
2.4.7 Door control
With its two relay outputs and two digital inputs DOG20 terminal is able to
control access on a single access point (door, gate …).
The door lock mechanism can be controlled by either one relay output
(single output mode) or two relay outputs (double output mode). In a
single output mode the output is activated for each granted door release
for a short period of time, as well as during time zones when the door
should remain open. In a double output mode the first relay output is
activated for each granted door release for a short period of time, while
the second relay is active during time zones when the door should
remain open.
Which mode should be used depends on lock mechanism type. For
example, simple door release requires single relay output mode, while
sliding door mechanism typically requires double output mode: one
14
DOG20 Installation and Setup Instructions